thequietwoman
2 discussion posts
We've just installed 2x Epson EB G6350 projectors (with in built edge blending) displaying an image 3990mm wide x 5840mm high. We have an AMD Firepro 2460 card with one output connected to each projector. The projectors have been configured and the edge blend is correct. Our issue is that when we configure the Eyefinity, it puts a bezel through the middle of the image that we cannot remove nor, compensate for (using the pixel overlap tab)
As these are projectors not, direct view displays, they have no bezel, the image should be seamless. Any ideas?
• Attachment [protected]: 1431649656335-1106157106.jpg [3,432,736 bytes]
Are you able to remove the bezel using the AMD control panel or drivers? I'm sorry, I'm not familiar with your projectors or that specific card, you might have more luck posting on an AMD or FirePro forum. Thanks!
thequietwoman
2 discussion posts
Hi Jon, thanks for your reply. No, we cannot. It's the card that's introduced the bezel. We can make it bigger but, not smaller - despite it having both bezel and edge blending adjustment. We installed Displayfusion hoping this would allow us to remove the bezel however, same thing...we can only increase it.
Can't seem to get any support out of AMD. Little old NZ, no-one bothers...😎.
Thanks again for replying, any ideas would be appreciated.
Cheers.
