Hi.
I am using a docked and closed laptop into a super widescreen monitor, and using the monitor-configuration to use splits, which works well. So I am using 2 monitor configurations, one for laptop only, and one for docked super widescreen monitor only (both only 1 monitor each).

On un-docking, using the laptop on its own screen, and then re-docking - DisplayFusion does not identify change of monitors and reload the correct monitor config, not putting back the new super wide screen monitor config with splits.

How can I fix this?

I have a workaround as I have allocated a keyboard shortcut combo to the super widescreen monitor, which I have to hit each time docked (a pain) to remember the splits again.

I'm on Windows 10.
Thanks & regards.

Sounds good. Many thanks Keith.

Do you know when this will be available to use?

Kind regards.

Any news on this?

Thanks & regards

Normally when docked the laptop is closed, so just the monitor is visible.

Thanks & regards

Laptop is 1366 x 768 - though not docked and not visible

Main screen is 2560 x 1080

Thanks

To clarify, the sequence is this:

1) Laptop closed and docked on uwd monitor
2) Undock and work on laptop open away from office desk
3) Go back to desk, with laptop closed again and re-dock to uwd monitor (only display)
3b) This is when DF does not 'detect' the new config and load my presaved monitor config (with split screen settings)

I just reproduced this now, and went to your Troubleshooting tab - Which errored! With the only line of text saying... Error: Result is invalid.

When used my workaround shortcut key on the monitor config to reapply it manually, and then went into the troubleshooting - it worked - export attached (but not in 'incorrect' state - 3b above).

Thanks.

But won't this run for any profile change, so when undocking and going to laptop only screen - loading the wrong profile?

I can't see how to put criteria into the trigger to address this. It would be useful if you could detect the resolution and use that in the trigger - then I could detect if the screen width was laptop only or larger.

Hi.

Still no luck.

Have attached 2 troubleshooting logs.

1 for after a redock, when the monitor profile is not detected and not reloaded.
2nd for after a manual reload of monitor profile.

Hope this helps so can fix

No it doesn't. See first screenshot - after dock monitor profile page.

And then I loaded the config, shown in the 2nd screenshot.

Thanks.

Success!

As asked ... I redocked, and saved that (no splits) profile as a new one.
Then changed the trigger to use that redocked profile, loading my main profile with the splits.

Thanks very much for all your help and patience on this

Kind regards,
Mark Rosten