JohnCoool1
20 discussion posts
On Windows Display 1 and 2 are ok but they have been for some reason swapped today after boot up on DisplayFusion 10.1.2
It is causing an issue with triggers. It is true that I can just change it on the trigger but I prefer to actually solve it properly.
I only have on display card but for some reason the system recognized 2 and shows each display is connected to a seperate one.
Please give me tips that do not require updating the driver.
Jun 28, 2024 (modified Jun 28, 2024)
•
#1
JohnCoool1
20 discussion posts
After a restart things seem to be back to normal.
However. Please advise a way to get it done without needing to reboot...
Updating the display drivers can cause monitor ID confusion in Windows and rebooting is recommended unfortunately.
