I'm simply trying to setup 2 profiles: one where monitors 1 and 2 are enabled and 3 is disabled, and another profile with the opposite setup. However, when I apply changes, it seems the changes are applied and then perhaps reverted, because I can never actually save the current profile. Upon clicking "Save Profile", I'm greeted with this message:

When I then click Apply again, the same thing happens in a loop:

• Monitors go black, then come back on
• monitors quickly blink and the apply button is enabled again
• Click apply

Thus, I'm never able to save the profile since it doesn't recognize that the changes have been applied. Reproduced around 12:40 pm

Thanks a lot! Is there a newsletter or something I can subscribe to to be notified when this update is out?

Brilliant timing. I literally just installed DisplayFusion again and ran into the same bug. Oddly enough for me it doesn't happen with every configuration. I have 3 monitors. If I disable the just third one I can't save the profile, no matter how often I click apply. If I disable the first one too, leaving just the second, save works.

I'm looking forward to the fix.

I had the same issue. Emphasis on had, as 11.1.1 was just released and it's now fixed for me! Thanks for the expedient update!

Same here. My issue is also fixed. Thanks for the quick fix!